My settings › Experimental is where unfinished features can be tried before they are done. Each experiment is off until you turn it on.

Where the Experimental page shows

  • Beta builds

    Supported
  • Development builds

    Supported
  • Stable builds

    The page and its switches never show

    Not supported

To get Beta builds, see Beta builds.

Turn an experiment on

  1. Open My settings › Experimental

    It is under This PC. Each row has the experiment’s name, what it does and what may change or break.

  2. Switch it on and click Save

  3. Find its command

    An experiment’s command goes on an Experimental panel on the ribbon, shown only while its switch is on.

Experiments now

ExperimentWhat it does
Symbol legendLists the device symbols in the project with their EL numbers and descriptions, to copy, export or place on a sheet. It needs Materials on. See Symbol legend.

What to expect

  • Experiments can change or break from one build to the next. Try them on a copy of the project.
  • The switches are yours. A project never turns an experiment on for a colleague.
  • An experiment never needs your colleagues to have Pembris Electrical or the same experiment on.
  • If you leave Beta, your choices stay saved and do nothing in a Stable build.
  • Your administrator can turn the page off for everyone. When settings are managed, the page shows its switches read-only.

Data an experiment keeps in a project

An experiment that keeps data in the open project says so under its row, such as "This project remembers the legend on 2 sheets", with Remove from this project…. That closes My settings, asking first about unsaved changes, and removes the data after its own confirmation, in one undo step.

Tell us what you think

Each experiment has Send feedback…, which opens Send feedback with its first line naming the experiment. See Send feedback.