My settings › General › Modules turns parts of Pembris Electrical on or off. A module that is off leaves the ribbon and the side pane, and its commands refuse to run. My settings stays available.
The modules
| Module | What it turns on or off |
|---|---|
| Route A→B | The Route A→B command. |
| Connect devices | The Connect devices command. |
| Drop to tray | The Drop to tray command. |
| Check routes, Check project and Re-route | The three commands and the Check routes page of the side pane. |
| Zones | The Zones tool. Saved Stay inside and Keep out zones still apply to routes. |
| Add to box | The Add to box command. |
| Materials | Materials, its counts and saved mappings. |
| Route watch | Whether the route watch may run at all. |
| Welcome after installing | The welcome window on the first start after an install. What’s new still works. |
Turn a module off
Open My settings › General
Under Modules, switch the module off
Clicking a row’s title toggles its switch too.
Click Save
Switch everything off
Enable Pembris Electrical, above Modules, turns every command off at once.