Pembris Electrical installs from a signed package (.cvpkg) that opens in Pembris Electrical Setup, a small program that runs outside Revit. Setup checks the package before it installs anything.
Install
Close Revit
Setup waits until every Revit on the PC has exited. While it waits, its install button stays, disabled.
Open the package
Setup checks that the package is signed by Pembris and reads which version, if any, is installed already. A package that isn’t signed by Pembris is refused.
Check what will happen
Setup shows both versions and says whether it will install, update or replace Pembris Electrical. Installing an older build shows a warning naming the version installed now.
Click Install
The button names the version, or says Update or Replace. When it has finished, Open Revit starts Revit again.
The first start
Revit shows a Pembris Electrical tab. Until a licence is active it holds only Activate: see Activate your licence. The tools appear as soon as you activate, without restarting Revit.
On the first Revit start after an install, a welcome window opens once (it needs an active licence). With a project open, its Route A→B button starts your first route; Close or Esc only closes it. On Revit’s start page it offers only Close and says to open a project first.
Updates and older versions
- When your company allows it, new versions download in the background and install when Revit closes. Every package is signed. See Updates and signed releases.
- To go back to an older version, open its package in Setup. It warns you and names both versions.