This walkthrough connects two devices with conduit using Route A→B. You pick the ends; Pembris Electrical finds the route, fits the elbows and checks it against the model before anything stays.
Before you start
- Pembris Electrical is installed and activated. See Activate your licence.
- A project is open, with two devices to connect, or a device and the open end of a conduit run.
- Sockets, switches and lights without conduit connectors are fine. The conduit ends at the device, and the review marks that end Not joined.
Route it
Click Route A→B
On the Route panel of the Pembris Electrical tab. If you select the two devices first, the picks are skipped.
Pick the start
Click a device or the open end of an existing run. A device that can’t be used, such as a box with every opening taken, says why in the status bar.
Pick the end
A small window shows progress while the route is planned, and lets you cancel.
Look at the suggestion
The route is drawn as real conduit, and the review opens in the corner of Revit with the ends, anything the route passes through, and any warnings.
Click Add conduit
Or press Enter. The conduit stays in the model as one undo step. No success message appears: the model shows the result.
What to check in the review
- Each end: a tick when joined, Not joined at a device without a conduit connector, or an amber Join refused if Revit refused the join.
- Permitted penetrations: elements set to Go through that the route passes, such as walls, beams and ceilings.
- Warnings, for example a run with more bends than your limit allows.
After you add the conduit, Pembris Electrical may offer to draw plan wires between the devices. Not now skips it. See Draw plan wires.
Next steps
- Route several pairs one after another: Route several pairs in a row.
- Choose other openings, a height or another conduit before you add: Change openings, layout and conduit.
- If no route can be made: When a route is refused.