Under More in the review, each Change choice applies to this route only. Nothing is written to your settings, and closing a Change window without choosing returns to the same suggestion.

Menu entryWhat you choose
Change openings…Which opening each end uses.
Change layout…Direction, height and conduits side by side.
Change conduit and fittings…The conduit type, with its elbow, and the size.
Change zones…Which zones the route uses, and where it enters them. See Use zones in a route.
Back to previousUndoes the last change.

Change openings

  1. Choose More › Change openings…

    The suggestion hides, and numbered markers appear beside every free opening, in the active view only.

  2. Choose an opening for an end

    Click Pick in view and click near the opening, or choose its row in the list: one row per run end, by number and direction, such as “top”. The list is the only way to choose overlapping or hidden markers.

  3. Review the new suggestion

    A chosen opening is fixed for that end in this command. Reset all clears your choices. The markers vanish when the picker closes.

Change layout

  • Direction: one of the four named directions, for this route.
  • Height: Automatic height, or At a height in millimetres above a level, typed or taken from a picked point.
  • Last used: the layout you last used in this project since Revit started, applied only when you click it.
  • Conduits side by side: 1 to 4 conduits between two devices that each have at least two free openings on one face, at a gap of 10 mm by default (0 to 300 mm).

Change conduit and fittings

Lists each conduit type once by name, with its elbow and sizes. A run you continue still decides the type, and an opening’s size still decides the size. A type without an elbow still offers a straight route where one is possible.

When choices compete, the route keeps to what is physically possible first, then chosen openings and a fixed height, then this route’s direction, then your settings.