Electricians often draw wires by hand in a 2D plan to show which devices are connected. After Add conduit on a Route A→B or Connect devices route, Pembris Electrical offers to draw those native Revit wires for you.

Add wires after a route

  1. Add the conduit

    Click Add conduit in the review. The Add plan wires? window opens.

  2. Choose the drawing

    Drawing (2D) is normally the current electrical plan. From a 3D view, it suggests a plan on the devices’ level; when several match, or the levels differ, choose one.

  3. Choose the wire type and style

    Wire type, then Style: Arc, Spline or Chamfered. Curve width (mm) starts at 300 mm and goes up to 30,000 mm; only Chamfered allows zero.

  4. Click Add wires

    The wires are added as their own undo step.

What gets a wire

  • Route A→B between two devices

    Supported
  • Connect devices networks

    Each accepted link between devices gets a wire; missing links get none.

    Supported
  • A route from an existing conduit run

    The wire goes to the device at the other end of that run.

    Supported
  • Several routes in a row

    The offer comes after each pair.

    Supported
  • Tray drops

    Not supported
  • Networks that continue existing conduit, and replacement routes

    Not supported

Routes from existing conduit

When a route starts or ends at an existing run, the wire goes between the devices at either end, found by following joins back through conduit and fittings to exactly one device. A tee, a pull point, an open end or a linked model stops the search, and the window says why.

Then click Pick the source device, or tick Use selected conduit ends to draw the wire at the open conduit ends the route used. Esc while picking skips the wire and keeps the conduit.

Remembered choices

After Add wires, the drawing, wire type, style and width are remembered per user and project, on this PC. They are offered next time, but nothing is drawn until you click Add wires.

Turn the offer off

Not now or Esc skips the wires this time. Don’t ask again stops the offer; turn it back on with Offer to add wire after routing in My settings › Routing. When the project’s settings keep the offer on, Don’t ask again says so and changes nothing.