Each command’s route search has a time limit and a step limit, so Revit never hangs. Revit waits while Pembris Electrical searches; a small window shows progress and lets you cancel.
Search harder
In My settings › Performance, the Search harder slider sets how long a route search may take, from Faster to Better routes. Higher limits find routes in big models, and Revit waits longer.
| Step | Give up after |
|---|---|
| Faster | 1 s |
| 2 s | |
| Middle (the default) | 5 s |
| 10 s | |
| Better routes | 20 s |
The slider sets Give up after below it. You can type your own time there, from 0.1 s to 60 s: the slider moves to the nearest step, and your time is saved as you typed it.
Time or steps
The step limit is internal and isn’t in the window. Where it ends a search first, more time doesn’t help; use Search further in the refusal instead.
| Fix in a refusal | Effect | Limit |
|---|---|---|
| Try again with more time | Doubles the time for this command | Up to the most your settings allow |
| Search further | Doubles the step limit for this command | Never past 8,000,000 steps; the time limit still applies |
Both fixes apply to this command only and never change your settings.
Look around the devices
Look around the devices, also in My settings › Performance, sets how far beyond the picked devices a route may go, in every direction: 3000 mm by default, from 500 mm to 50,000 mm.
Memory
Model work also stops when memory is low, and the command rolls back. After severe memory problems, model work stays off until Revit restarts. See Low memory stops model work.