Pembris Electrical is built so Revit never waits without a limit: every route search has a time limit, checks run a few routes at a time, and you can cancel. If Revit still feels slow, these are the settings that decide how long it waits.

A route search takes long

  • While a route is planned, a small window shows progress and lets you cancel.
  • Each command’s search stops at its time limit. Search harder in My settings › Performance steps it through 1, 2, 5, 10 and 20 seconds, from Faster to Better routes.
  • Higher limits find routes in big models, but Revit waits longer.
  • The first command after Revit starts takes longer, because it pays for start-up.
Setting in PerformanceWhat it doesDefault
Search harderHow long a route search may take, as a slider5 s
Give up afterThe same time limit, typed: 0.1 to 60 s. A typed time moves the slider to the nearest step.5 s
Look around the devicesHow far routes may go beyond the devices, 500 to 50,000 mm3000 mm
Trays searched per deviceHow many trays one tray drop searches, nearest first, 1 to 164
Additional memory allowanceExtra memory Drop to tray may use, 64 to 4,096 MiB512 MiB

Checking routes

  • Check routes and Check project never hold Revit: they check a few routes at a time while you pan, select and edit. Stop [Esc] keeps what was checked.
  • Check routes checks 100 routes at a time and Check project 500. Check next routes takes the next lot.
  • The side pane does no work while it is hidden.

After you edit the model

The route watch checks affected routes when Revit is idle, one route at a time, and pauses for new edits. If it slows editing down, it switches itself off for the session and notes it in the log. After a very large change, over 2,000 elements, it says "too many changes" and offers Check view instead. To stop it, choose Don’t watch in My settings › Checks.

If it is still slow

  1. Note what you did

    The command, the view and roughly how long it took.

  2. Collect diagnostics

    My settings › Diagnostics › Collect diagnostics saves the logs, which record how long each step took.

  3. Send them to support

    See Collect diagnostics.