An older build of Pembris Electrical marked its routes with a route stamp that Revit can’t use alongside the current one. Once Revit has read the older stamp in a session, Pembris Electrical can’t stamp new routes, so routing stays off until the older stamps are removed and Revit is restarted.
What you see
When you start Route A→B, Connect devices, Drop to tray or Re-route in such a project, a window titled "This project has route stamps from an older build" lists the elements that carry them, grouped by route, with when each was first stamped and in which version.
| Button | What it does |
|---|---|
| Cancel | Closes the list. Nothing changes, and routing stays off. |
| Select in model | Selects the listed elements so you can look at them. |
| Remove N stamps | Removes only the route stamps, in one undo step, after you tick "I understand: only the route stamps are removed; the elements stay." |
Remove the stamps
Start a routing command
The list opens before anything is picked.
Tick I understand
Then click Remove N stamps.
Save the project
The project isn’t saved automatically. Until you restart, Undo restores the stamps.
Restart Revit before routing
Routing works again after the restart.
“Routing is off for this project”
If Revit read the older stamps from another project earlier in the session, routing is off in the next project too, with nothing to remove there. If the project with older stamps was opened after a current one, it can’t be cleaned in that session. In both cases, restart Revit and open the project with the older stamps first.