Every route Pembris Electrical draws remembers what it connects: each device, tray or run it meets, where, and how that device sat. Check routes compares the model with that record, so it can tell a real change from the route’s own pieces. Record ends accepts a change in one click.
What the record holds
- One entry for each place the route meets a device, tray or run, in planning order. A chain’s middle device appears twice.
- The opening it uses, the end point, and the device’s turn, level, host and type at the time.
- Every route element carries it, fittings Revit adds included.
When to use Record ends
| Finding | What Record ends does |
|---|---|
| A device moved or turned, and that was meant | Accepts its new position. The finding goes. |
| Added by an older version | Gives the route a record. |
| Split by hand, Edited by hand | Makes those parts part of the route. |
| Run data out of date | In a run data project, also refreshes the run’s totals in the same undo step. |
Record one route or several
Open the route in Check routes
Or tick several routes.
Choose Record ends
From the finding, or under More. Each route is checked again first.
Check the result
It is one undo step. One Undo brings the finding back.
Record ends is offered only when the route was found whole and still meets every device. Record all records only older routes without a record that still meet their devices. A moved, turned or split device is never accepted in bulk: each needs its own Record ends.
Split parts and conduit drawn by hand
Split Element leaves the new part without Pembris Electrical’s stamp. Check routes finds such parts by following connectors from the route, never by searching the model: a part with both ends on a route conduit’s centre line and the same type and size, conduit drawn straight on from a route’s end with its type and size, or a chain of conduit and two-way fittings joining the route’s pieces or leading to its devices. Record ends stamps them as part of the route and changes nothing else about them.
Devices and trays in a linked model
| What happened to the link | Check routes says |
|---|---|
| The link instance is gone, or the link loaded without the element | Deleted |
| The link isn’t loaded | Not checked, naming the linked model |
| Otherwise | Compared like a tray in your own model |
Re-linking a model gives it a new instance, so its routes report the tray deleted. Run Drop to tray again or delete the route.