Check routes is the large button on the Check panel. It opens the Pembris Electrical side pane on Check routes and checks the routes of the Pembris Electrical elements you have selected or, with nothing selected, those in the active view. Conduit someone else drew is listed and checked next to ours.
How checking works
- Check routes opens at once and checks a few routes at a time while you pan, select and edit. A line at the top says how far it is, such as "Checking routes… 34 of 100 in this view", with Stop [Esc].
- Up to 100 routes are checked at a time. Check next routes, at the end of the list, takes the next 100. Stop keeps what was checked.
- Checking pauses while the pane is hidden or another project is active. After an outside change, the routes it touched are checked again; Refresh checks the current model again.
- Checking is read-only. Nothing in the model changes until you click a fix.
Reading the list
Routes are grouped by their worst finding: Needs a look, Notes and Other routes. A row shows the devices, By hand for conduit Pembris Electrical didn’t draw, the worst finding with "+N" for the rest, and a chevron that opens the route. Search covers device, obstacle and tag; Filter narrows the list to Needs a look, Notes, Not checked or Drawn by hand. Lines at the top show only the most important notice, such as Model changed with Refresh; the rest wait under N more notices.
What the findings mean
| In the pane | Group | What it means |
|---|---|---|
| Runs through a duct; Too close to a cable tray | Needs a look | A clash with something set to Avoid, or something inside the clearance. |
| Light L7 is in the way; Light L7 was deleted | Needs a look | A device the route connects is in its way, or is gone. |
| Not connected at Light L7; Light L7 moved and pulled the conduit | Needs a look | An end came off its device, or was dragged with it. |
| No longer reaches Light L7; Not joined at Box B3 | Needs a look | The route is incomplete, or an end isn’t joined. |
| Too many bends; A bend has no fitting | Needs a look | Over the bend limit, or conduit joined at an angle with no fitting. |
| Breaks a zone rule | Needs a look | The route breaks a Stay inside or Keep out zone. |
| Light L7 turned 90°; A copy of this route; Something else is joined to it | Note | A device turned, the route was copied, or other conduit joins it. |
| Added by an older version; Its record is damaged | Note | The route has no usable record of its ends. |
| Split by hand; Edited by hand; Leaves a preferred zone | Note | Part of it was split or redrawn, or it leaves a Prefer zone. |
| Run data out of date | Note | Only in projects with run data. |
| Clashes not checked; Zones not checked | Not checked | That part couldn’t be checked. It always says why and is never "fine". |
One route
Open a row to see its findings, worst first, with the top one open showing its fix and Show in view. Limits has a Bends bar while the bend check is on: red over the limit, amber within 10% of it, grey otherwise. Route details shows Start, End, Length, Conduit and Zones. Previous and Next sit top right.
Show and the red highlight
Show lights one route and zooms to it without selecting anything. On a problem it selects what the finding names, fades the route and draws the damage in red. Open in 3D uses an existing 3D view and changes no view settings. The highlight never changes the model; its colours are in My settings › Appearance.
Keys
- Enter
- Open the focused route (from Search, the first route)
- Up
- Previous row
- Down
- Next row
- F8
- Next route that needs a look
- Shift+F8
- Previous route that needs a look
- Esc
- Close a menu, clear the search, cancel a copy’s picks, then go back to the list