Re-route plans a Pembris Electrical route again between the same devices and replaces it after you review it. Use it after a device moved, a duct was pushed into a route or a run has too many bends.
Re-route from the ribbon
Select a conduit or fitting of the route
Or click Re-route on the Check panel first and pick one.
Click Re-route
It uses the recorded devices, including devices that moved, and treats the old route as absent.
Review the suggestion
Add conduit replaces the old route in one undo step. Cancel keeps the old route.
Several routes in one review
In Check routes, tick routes and click Re-route N…. Ticked routes, or the routes at one moved device, share one review, one undo step and one search budget. Each replacement keeps its route ID and its zone choices.
- A route that can’t be planned is named first and left as it is. The main button reads Replace N of M routes, and Cancel is the default.
- If the search budget runs out, the whole batch is refused.
- With run data on, a run keeps its name when its pull points still match.
Tray drops
Re-route also handles single tray drops, keeping their original tray, size and supported drop content. A single device-to-tray drop to a tray in a linked model can be re-routed; any other route with an end in a linked model can’t.
When Re-route isn’t offered
| Why | What to do |
|---|---|
| Fewer than two recorded devices, or a recorded device was deleted | Use Route again…, or remove the route. |
| The route wasn’t found whole | Click Refresh, then look at the route with Show. |
| It includes a copy | Adopt the copy first. |
| Parts were split off or drawn by hand | Use Record ends first. |
| Pinned elements, elements in a model group, or elements another user owns | Unpin, ungroup or get the elements back, then try again. |
| Conduits side by side between two boxes | Re-route is refused for these and says why. |
| Conduit Pembris Electrical didn’t draw | Re-route never changes it. |