Skip to main content
Check panel

Re-route

Plan a route again between the same devices, even after they moved.

Select a conduit or fitting from a Pembris Electrical route and Re-route plans it again between its recorded devices, including devices that moved. The replacement is reviewed first and swaps in as one undo step; Cancel keeps the old route.

Overview

  • Same devices, new route

    It uses the route’s record of what it connects, so a device that moved is followed.

  • Reviewed first

    The replacement shows in the normal review, treating the old route as absent.

  • One undo step

    Several ticked routes share one review and one undo step.

What it supports

Each capability and its status today. Planned items are on the roadmap, not yet built.

  • Supported
  • Partial
  • Planned
  • Not supported

Re-routing

  • One route from a picked conduit or fitting

    Supported
  • Several routes in one review

    Ticked routes, or those at one moved device. A route it can’t plan is named and left as it is.

    Supported
  • Tray drops

    Keeps their tray, conduit type, size and drop content.

    Supported
  • Keeps the route’s ID and zones

    Run data keeps the run’s name when its pull points match.

    Supported
  • Routes with a linked end

    Only a single drop from a device to a tray in a linked model.

    Partial

What it won’t do

  • Conduit Pembris didn’t draw

    Re-route fixes only routes Pembris Electrical added.

    Not supported
  • Routes with a copy, pinned, grouped or borrowed elements

    Adopt a copy first; the others are refused and nothing changes.

    Not supported
  • Write part of a network

    A network is replaced whole or not at all.

    Not supported
  • Move devices

    It routes to the devices where they are now.

    Not supported
  • Revit 2025Supported

    Autodesk Revit 2025 on Windows.

  • Revit 2026Supported

    Autodesk Revit 2026 on Windows.

  • Linked modelsPartial

    Only a single drop from a device to a tray in a loaded link; other routes with a linked end are refused.

  • MagiCAD contentPartial

    MagiCAD families work like any other Revit family; there is no MagiCAD-specific handling.

  • Conduit drawn by handNot supported

    Re-route fixes only routes Pembris Electrical added.

Settings

Where to change how it behaves.

My settings › Routing
Clearance and the bend limit, as for Route A→B.
My settings › General
Check routes, Check project and Re-route turn on and off together.

Guides for Re-route

Open collection