Pembris Electrical watches Revit’s memory while it reads, plans and writes. When memory runs low it stops model work rather than risk the model, and tells you.
What happens
| Situation | What Pembris Electrical does | What you do |
|---|---|---|
| A command would use more than its allowance | Refuses that command and rolls it back. Nothing is added. | Try again with fewer devices or routes at a time. Other commands can still run. |
| Memory is severely low or can’t be read, Revit runs out of memory, or clean-up fails | Stops all model work for the rest of the Revit session, including queued actions in Check routes and route watch repairs. | Save your work and restart Revit. |
The allowance
- Each command may use up to 512 MiB more memory than when it started, retries included, while a reserve of free memory is kept as well.
- A batch Re-route has the same 512 MiB. Drop to tray uses Additional memory allowance in My settings › Performance: 512 MiB by default, 64 to 4,096 MiB.
- A preview you accept is checked again before it is kept.
After restarting
Restarting Revit starts a new session, and model work is available again. The stop isn’t lifted when memory frees up later; only a restart lifts it.