When no route can be made, nothing is drawn and the refusal says why. It names at most two elements in the way, never the devices, and offers its fixes as buttons, safest first, so pressing Enter never routes through anything.
One-click fixes
| Fix | Offered when | What it does |
|---|---|---|
| Show in view | The refusal names elements | Selects and zooms to them, in a linked model too. Esc brings the refusal back, with Try again first. |
| Choose openings | Other openings might work | Opens Change openings for this route. |
| Change layout | There are too few separate openings | Opens Change layout for this route. |
| Smaller conduit this time | The default size decided it | Plans one size down. |
| Search further | The search reached its step limit | Doubles the step limit, never past 8,000,000 steps. |
| Try again with more time | The search ran out of time | Doubles the time, up to the most your settings allow. |
| Reduce clearance this time | Clearance is what is in the way | Halves the clearance, in whole millimetres. |
| Route through Ducts this time (or another kind) | One kind of Avoid element alone blocks the route | Lets the route pass through that kind for this command. |
| Show it with a warning this time | Every route is over the bend limit and your settings say not to suggest it | Shows the route with a warning. |
| Ignore this link | A linked model is unloaded | Asks first, then saves the link to your settings. |
Fixes apply to this command only and stay on in its later rounds. Closing a fix’s window shows the refusal again.
Common reasons
- An element set to Avoid blocks every way out, such as a duct or a column.
- A device has every opening taken. Each opening is used once.
- There are too few free openings for conduits side by side.
- The search ran out of time or steps. See Route search time and Search harder.
- Every route breaks your bend limit. See Bend limits and pull points.
- A linked model is unloaded, or a workset is closed.
- Memory is low. See Low memory stops model work.
- The project has route stamps from an older build. See Route stamps from an older build.
Unloaded linked models
An unloaded or missing linked model, or a closed workset, stops routing before anything is written, because Pembris Electrical can’t see what is in it. The message names the link as Manage Links shows it. Reload the link, or choose Ignore this link.
Don’t ask again in that question skips every unloaded link from then on. Turn it back off in My settings › Obstacles. See Linked models.