Connect devices, on the Route panel, plans the conduit between several devices (boxes, sockets, lights, a panel) as one network. You review the whole network, add it as one undo step and change it as a whole, not link by link. For a single route between two devices, use Route A→B. To run each device to a cable tray, use Drop to tray.
Connect a group of devices
Choose the devices
Select two or more devices before you click Connect devices, and the list fills from your selection. Otherwise click Connect devices and pick: a click adds a device, a second click removes it, and a box selection only adds. A bar at the top left of the view shows the count, with Cancel and Done.
Check the list
Pick devices and Box select sit under the list. More holds Add devices in view without a route, Add circuit… and Clear all.
Choose where it starts
Start at offers Automatic or any device in the list. The chosen row gets a Start tag. See Chain or tree?
Click Suggest route
Suggest route shows once the list can be routed. Until then, the line under the list says what it still needs.
Review and add
Look over every run and any missing links, then click Add conduit. Cancel discards the preview.
- Esc
- End picking devices (the same as Done or Cancel on the bar)
Start from Route A→B
Select three or more usable devices and click Route A→B. It offers Connect these N or Pick two. Connect these N goes straight to the review. With over 50 devices, or a selection the list would refuse, the list opens instead so you can fix it.
What the list takes
What Connect devices takes
- Supported
Boxes, sockets, lights and panels in this model
- Supported
Devices without a conduit connector
While **My settings › Devices › Conduit can end at devices without a conduit connector** is on, as it is by default.
- Supported
Up to 50 devices in one network
- Not supported
Devices in a linked model
- Not supported
Devices with every opening already connected
- Not supported
Existing conduit, cable tray or their fittings
They are left out and counted, never taken as devices.
One sentence before Suggest route says what was left out and why. Click order doesn’t change the network. Your Revit selection comes back when the step ends.
Keep from the box
When a box selection adds more than one kind of device, Keep from the box shows one chip per family it added, with the count. Turn a chip off to take that type’s boxed devices out of the list, and on again to put them back. Devices you listed before the box are never part of a chip.
When some links can’t be planned
With three or more devices and no complete network, the review may offer a partial one. It names each missing pair and why. Cancel is the default and the main button reads Add N of M links. After you add, a notice names the pairs still to connect.
What it doesn’t do
- No branch fittings, junctions or shared trunks. Each link is its own run, and no two links share an opening or overlap. A shared trunk with real junction fittings is on the roadmap.
- It never takes more than 50 devices. Over that, the list says how many to remove and hides Suggest route.
- It never moves an opening you chose in Change openings. A link that fails there is named, not replaced.