Drop to tray can drop rigid conduit or flexible conduit, with or without a clamp where the drop meets the tray. You choose in More › Change drop options.

Change the drop options

  1. Open Drop options

    In the Drop to tray review, choose More › Change drop options. A refusal can offer it too.

  2. Choose the content

    Pick rigid conduit or a supported flexible product, and a clamp for each conduit size if you want one.

  3. Set the reach

    How far to look for a tray, from 500 to 30000 mm.

  4. Review again

    The drops are planned again with the new choices.

Drop options are remembered for this document until Revit closes. They aren’t saved in the project or in your settings.

What each option uses

Drop contentWhat it uses
Rigid conduitThe device’s conduit size and the project’s conduit types.
ABB Adaptaflex SN20, SN25 or SN32A flexible conduit fitting Pembris makes for each drop, with real conduit connectors and the product’s catalogue diameters and bend radii.
Cablofil clamps (optional)Clamp content found in the model, checked for each conduit size before use.

Why a flexible drop is a fitting

Revit has no flexible conduit element. Its flexible elements are flex pipe and flex duct, which would put plumbing or ductwork in your model. So Pembris builds each flexible drop as a Conduit Fittings family with conduit connectors at its ends, and loads it in the same undo step as the drop.

Clamps

  • A clamp is used only after its identity, type, dimensions and geometry are checked for that conduit size. A name alone is never enough.
  • Pembris looks at up to 128 nearby Data Devices to find clamp content.
  • Clamps join the drop at their measured connection points.
  • If a clamp you chose is deleted or changed, the drop is refused before anything is written, and Drop options is offered.

Re-route keeps a drop’s tray, conduit type and size, flexible product and any clamp that is still there.