Connect devices links your devices in one of two shapes. Both begin at the start device, and both are reviewed and added as one undo step.

A chain runs from device to device; a tree grows from the start device for the shortest total length.
ShapeHow it linksGood to know
ChainEach device to the next, beginning at the start device.A device in the middle needs two free openings, one in and one out.
TreeThe shortest total length, growing from the start device.If a link fails, a cut-off part can be joined to another connected device instead.

The default shape is set in My settings › Routing. It is Chain unless you change it.

The start device

Start at offers Automatic or any device in the list. Until you choose, the first listed piece of electrical equipment, such as a panel, is suggested. A start you choose, Automatic included, stays until you remove that device from the list.

Openings

  • Every link needs its own usable opening. Two openings closer than one conduit outside diameter can’t both be used.
  • An opening that points into a device or an obstacle can’t be used.
  • When there aren’t enough openings, the refusal names the device and its openings.

One common height

In the review, More › Change layout sets the height: each run its own (the default), a suggested common height, or millimetres above a level. With a common height, every horizontal run sits at it, apart from the short lead-outs and approaches at the devices, and nothing goes below the lower of the ends and that height. A height you fix is never swapped for another.

Devices that are already joined

When a conduit end already rests on a picked socket, the review says once that they are already joined, and no run is drawn between them.

How the network is chosen

Pembris plans the first layout, then a few alternatives within the search time, and keeps the cheapest complete one. That is a good network, not a proven best one. The same devices and settings give the same network.