A project can set a target for how much conduit lands on each receiving tray section. With it on, Drop to tray skips trays over the limit, and Check project reports each section’s estimated load. It is off until a project turns it on.
Set a project target
Open the policy
In Drop to tray, choose More › Change drop options › Project tray capacity….
Turn on Estimate landing load
Then set Design target (%) and Reserve (% of target).
Click Save project settings
The policy is saved in the project’s Project Information, as one undo step. Cancel, and planning drops, never save it.
| Option | Default | Range |
|---|---|---|
| Estimate landing load | Off | On or Off |
| Design target (%) | 40 | Above 0, at most 100 |
| Reserve (% of target) | 20 | 0 to below 100 |
- Effective limit
- target × (1 − reserve ÷ 100), so 40% with 20% reserved permits 32%
Invalid values are refused, never quietly adjusted. In a workshared model, saving may borrow Project Information. Pembris never relinquishes it or synchronises for you.
What is counted
- The outside area of each round conduit drop recorded in this model, once per drop, over the receiving tray’s nominal width × height.
- Not counted: cables passing through or coming from outside, sections further along the tray, and drops in linked models. A linked tray can still receive drops from this model.
When capacity is unknown
Unknown capacity is never treated as room. Copied drops, including parts Revit split off, and unknown conduit sizes make a section unknown until its drops are recorded again (see Record ends). Missing or unreadable records, or tray fittings as targets, refuse the whole estimate. A policy that can’t be read blocks Drop to tray rather than assuming it is off.
In the review
The review shows each section’s load before and after the drops, its limit, any warnings and why devices were skipped. Trays over the limit are skipped, a tray you picked included. Drops planned earlier in the batch count against the limit for the devices after them, and the review says to retry the skipped devices.