Add circuit… fills the Connect devices list with every member of a Revit circuit and its panel, so you don’t pick them one by one. You pick one device in the circuit and Pembris adds the rest.

Add a circuit

  1. Open the device list

    Click Connect devices on the Route panel.

  2. Choose More › Add circuit…

    Then pick one device that belongs to the circuit.

  3. Choose the circuit if asked

    When the device is on several circuits, choose one by circuit and panel. Only circuits the device belongs to are offered.

  4. Check the start

    The circuit’s members and panel join the list once. The panel replaces an earlier automatic start suggestion; a start you chose yourself stays.

  5. Click Suggest route

    Review the network and click Add conduit. One Undo removes it.

When a circuit can’t be added

Any of these refuses the whole addition, and the list stays as it was:

ProblemWhat to do
The circuit has no panel assignedAssign the panel in Revit, then add the circuit again.
A member or the panel can’t be used, for example it is in a linked modelAdd the usable devices by picking instead.
A member has every conduit opening already connectedThis action doesn’t complete an existing network. Pick the remaining devices yourself.
The circuit has over 50 devices, panel includedSplit the work into smaller groups.
The picked device has over 50 attached electrical systemsAdd the devices by picking instead.

Cancelling while you choose the circuit leaves the list unchanged.