Enabled Keep out zones always apply, and nearby Prefer zones apply by themselves. To choose the Stay inside and Prefer zones for one route, use More › Change zones in its review, or after a refusal.

Choose zones for a route

  1. Open More › Change zones

    In the review of Route A→B, Connect devices or Drop to tray. The preview is rolled back first.

  2. Choose automatic, chosen zones or none

    For Stay inside and Prefer zones, for this route only.

  3. Pick an entry point (optional)

    Pick entry point takes a clicked point for each device, where the route enters the zone. How far to reach is 3,000 mm by default, up to 100,000 mm per device.

  4. Review the new suggestion

    Add it as usual. The zone choices are saved with the route, in the same undo step.

Your choices carry through retries and refusal fixes in the same command. They aren’t carried to the next route of Add and route next. Selecting a row in the Zones window never changes a route.

Stay inside

  • A Stay inside zone is the space the route must use, not a place to visit. A route can’t leave it and come back in.
  • Only the first and last stretch may be outside, to reach the devices.
  • Reaching a device never overrides Keep out, obstacles, chosen openings, a fixed height or clearance.

Suggestions that drop a Prefer zone

With several suggestions on, up to three may leave out a Prefer zone, but only when that saves at least 100 mm, 5% or a bend, and never when it is over 1.5 times as long or adds more than two bends.

Default height: above the ceiling

Separate from project zones, My settings › Routing › Default height gives every run a preferred band. Horizontal travel outside it costs extra; vertical travel doesn’t. A fixed common height wins over it.

Default heightWhere runs prefer to be
Above the ceilingThe void between the highest ceiling over the run’s two devices and the floor or roof above. With no ceiling, the band under the slab.
Under the slabA band under the slab, 600 mm deep by default (100 to 5000 mm).
OffNo preferred band.

When zones change later

Re-route uses the zones as they are now. If a zone a route had to stay inside was removed or changed, choose again. A zone change queues a review-only check of the routes it may affect, through Route watch. Anything that can’t be checked reads Zones not checked, never all clear.