Zones
Say once where conduit belongs, and every new route follows it.
Tell Pembris where conduit should run: in the void above a suspended ceiling, along a chosen corridor, or away from a space that must stay free. You say it once, in the model, and every route follows it.
Overview
Prefer, Stay inside, Keep out
Saved spaces in the project, each with one behaviour. Keep out always applies.
The ceiling void by default
Default height keeps runs above the ceiling, or under the slab where there is no ceiling.
Existing conduit untouched
Zones guide where new conduit goes. They never change existing conduit or move devices.
What it supports
Each capability and its status today. Planned items are on the roadmap, not yet built.
- Supported
- Partial
- Planned
- Not supported
Default height
- Supported
Above the ceiling
The void between the highest ceiling over the run’s devices and the floor or roof above.
- Supported
Under the slab
A band of the depth you set, 600 mm by default.
- Supported
A preference, not a rule
The review names a run that leaves the band and how far it runs outside.
Project zones
- Supported
Boxes, level bands and corridors
Drag a rectangle in a plan or orthographic 3D view, or type a corner and size.
- Supported
Choose zones per route
More › Change zones in a review picks the Stay inside and Prefer zones for that route.
- Supported
Pick entry point
Click where the route should enter a zone, per device.
- Supported
Edit, duplicate, disable and remove
Each one undo step; existing conduit stays as it is.
- Partial
Above ceiling or Under slab sources
They are approximate boxes, so Prefer only until converted to a manual box.
- Not supported
Change conduit when a zone changes
A zone change only starts a check, for review.
Next
- Planned
Rotated or arbitrary footprints
- Planned
A zone from rooms or ceilings in one step
- Planned
Native grips and presets
Compatibility
- Revit 2025Supported
Autodesk Revit 2025 on Windows.
- Revit 2026Supported
Autodesk Revit 2026 on Windows.
- Linked modelsSupported
Ceilings, floors and roofs in loaded links set the default height, and zone sources follow links.
- MagiCAD contentSupported
Zones are about space, so they work whatever device families you use.
- Conduit drawn by handPartial
Zones never change existing conduit; Check routes reports a run drawn by hand that breaks a Keep out or Stay inside zone.
Settings
Where to change how it behaves.
- My settings › Routing › Default height
- Above the ceiling (new settings start here), Under the slab or Off.
- My settings › Appearance
- The colours Prefer, Stay inside and Keep out zones are drawn in.
- My settings › Checks
- Whether routes are checked against zones.
- My settings › General
- Turns the Zones tool on or off. Saved Stay inside and Keep out zones still apply.
Guides for Zones
- Draw zonesDraw spaces in the model that routes prefer, stay inside or keep out of, each saved as one undo step.
- Use zones in a routeChoose which Prefer and Stay inside zones a route uses, where it enters them, and how the ceiling-void default height works.
- Avoid or Go throughDecide which kinds of element routes keep clear of and which they may pass through, and see the defaults.
- Rules for your own familiesAdd Avoid or Go through rules for a category, family or type the built-in groups don’t know, such as a glass Generic Model.
- Linked modelsHow routes, tray drops and devices treat linked models, and what happens when a link is unloaded.