The Avoid or Go through groups can’t know your project’s own families. A rule covers what the groups don’t: a category, optionally narrowed to families or types whose name contains some text, set to Avoid or Go through.
Add a rule
Open My settings › Obstacles
Add a rule for a category, family or type.
Choose the category
Use Pick from model to click an element in this model: the window hides, takes one pick, and reopens with your draft as it was.
Add name text (optional)
The rule then applies only where the family or type name contains it, ignoring case.
Choose Avoid or Go through, then Save
New routes follow the rule.
| Example | Rule |
|---|---|
| Glass panels modelled as Generic Models | Generic Models, name contains “Glass”, Avoid |
| Grilles a route may pass | Air Terminals, name contains “Grille”, Go through |
Which rule wins
- A rule for the category whose name text matches.
- A rule for the category without name text.
- The group switch.
When two rules at the same level disagree, Avoid wins.
Where rules apply
- To elements in this model and in linked models.
- In every project, language and Revit version: a rule is stored by Revit’s built-in category, not its translated name.
- In your settings on this PC, never in the model, unless a project sets rules for everyone.