Zones lets you say once, in the model, where conduit belongs: in the void above a suspended ceiling, along a chosen corridor, or away from a space that must stay free. Each zone is a saved volume with one behaviour, and every new route follows it. Zones guide new conduit; they never edit existing conduit or move devices.

Prefer, Stay inside and Keep out zones, and how a route treats each.
BehaviourWhat a route doesWhen it applies
PreferUses the zone when it is worth the detour, and may leave it.Nearby Prefer zones apply by themselves. You can also choose them for a route.
Stay insideFits inside the zone, conduit, fittings and clearance included. Only the first and last stretch, at the devices, may be outside.Only on a route you choose it for.
Keep outNothing of the route enters the zone.Always, while the zone is enabled.

Draw a zone

  1. Open Zones

    Click Zones, or Zones on the side pane’s Home. It opens in its own window.

  2. Click Draw zone

    Drag one rectangle in a plan or an orthographic 3D view.

  3. Set the heights and the behaviour

    Set Bottom and Top, then choose Prefer, Stay inside or Keep out.

  4. Click Save zone

    A zone can’t be saved without an area. When something is missing, the reason shows under the form.

Exact sizes and corridors

  • Corner and size takes exact values: X and Y (or Pick corner, which moves the section and keeps its size), Width and Depth, beside Bottom and Top, all in millimetres.
  • Numbers follow your Windows format: 1200,5 in Norwegian, and 1200.5 works too. A field that can’t be read is named under it.
  • Besides a box, a zone can be a level band or a corridor of connected sections. Draw next section adds a section, risers included. It snaps to a horizontal face within 150 mm and refuses a section that doesn’t connect. Esc keeps the earlier area.
  • A zone can also come from the space above the ceiling or under the slab. These follow the model but are approximate boxes, so they act as Prefer until you convert them to a box you have checked.
Alt+S
Save the zone
Alt+B
Go to Bottom
Alt+T
Go to Top
Alt+X
Go to X (Alt+Y for Y)
Alt+W
Go to Width (Alt+H for Depth)
Alt+C
Pick a source
Alt+R
Remove a section

Show, hide and change zones

Saved zones stay drawn, with labels you can click to reopen them. View › Show in view frames the zone you are drawing or have chosen; View › Hide all, View › Show all and a row’s More › Show zone or Hide zone change only what you see in this session. Edit, Duplicate, Disable and Remove are each one undo step. A disabled zone stops applying to new routes.