Add to box, on the Devices panel, adds an outlet, switch or cover to existing mounting boxes, one box or many at once, without drawing it by hand. Each device is a separate element, centred on the box face and facing the room, that you can select, tag and schedule like any other.

Add devices to boxes

  1. Choose the boxes

    Select the boxes and click Add to box. When asked, pick the room-facing flat mounting face once for each box type. Or start without a selection and pick mounting faces one by one; pick a box again to remove it, and click Done or press Esc when you are finished.

  2. Choose the device

    Choose one loaded type for all the boxes. Search matches family and type words. The device you added last time is selected when it is available.

  3. Check the types (optional)

    Types start as Not checked on selected boxes. Check all types tries each one on every selected box and rolls every trial back.

  4. Review and add

    The batch is highlighted. Check each device’s fit, then click Add device. Cancel is the default, so Enter never keeps a preview.

Esc
Finish picking mounting faces (the same as Done)
Space
Add device, in the review

What it works with

What Add to box takes

  • Electrical boxes in this model

    Top-level electrical family instances, any number at once.

    Supported
  • Linked, grouped or nested boxes

    Not supported
  • A box face that already has a device, or a box another user owns

    Not supported
  • Face-based device families

    Supported
  • Work-plane-based and unhosted families

    With **Include devices that aren’t face-based** on. Unhosted devices don’t move with the box, and the chooser and review say so.

    Partial
  • Families that need a wall, floor, ceiling, roof, two levels, curves or adaptive points, and families that cut their host

    They are listed under **Unavailable types**, with the reason.

    Not supported

Which families the chooser lists

My settings › Devices › Families in the chooser decides which categories Add to box offers. These only filter the chooser; every placement still passes its own checks.

CategoriesDefault
Electrical Fixtures, Lighting Devices, Data, Communication, Fire Alarm, Security, Telephone, Audio Visual and Nurse Call DevicesOn
Electrical Equipment, Lighting Fixtures, Generic ModelsOff
Other Model Categories (never annotation)Off
Include devices that aren’t face-basedOff

Restore defaults on that page returns to nine on and four off. All off is allowed and leaves the chooser empty. The chooser refuses over 2,000 types rather than show part of the list.

Checking types

Check all types tries every candidate on every selected box, ignoring the search, and always rolls the trial back, with no Undo entry. Types that pass read Checked on selected boxes; those that fail move to Unavailable types with the reason. Checking stops after 60 seconds of work. Cancel keeps the results so far, and Check remaining types carries on.