While you place devices, the preview shows the type’s real body where the click will put it, turned square to the face. This is how it chooses that spot.

What it snaps to

  1. An empty box of a known type.
  2. A height already used nearby.
  3. Otherwise, on a wall outside a floor plan, the nearest 50 mm.

Along the face it lines up above or below other devices, then keeps even spacing: a repeated gap, the middle, or the row spacing. Press Alt to place at the cursor instead. Devices sit square to flat, curved and sloped faces: upright on walls, top up a slope. Ctrl rows follow curves and run level along slopes.

Height and the lock

  • Height counts from the highest building storey at or below the device.
  • Locked, every wall click uses that height, and only a box at that height takes the device. A device with a saved default height starts locked.
  • Unlocked, the height follows the cursor. A height you type lasts until placing stops and is never saved.

Box + face

For a device with a box, Box + face places the box, then the face into its front. Over an empty box, only the face goes in. Box only never snaps into a box. Face only places just the face. Press F to toggle the face.

Hosts

Family kindWhere it goes
Face-basedAny face the view shows: walls, ceilings, floors and roofs, in this model or a loaded link.
UnhostedStands at the spot, turned only about the vertical. It doesn’t follow the face, and may stand beside a linked face.
Wall-hostedOnly walls in this model, facing the side you clicked. A type that can’t be flipped is refused on the back side.
Ceiling-, floor- and roof-hostedOnly that host kind, in this model.

Floor plans and Overhead

  • In a floor plan, a device goes on the nearest shown wall face within about 20 pixels, facing away from the wall, at Height above level. Away from walls, the bar says why.
  • Place on switches between Wall and Overhead (U). Overhead looks straight up to the nearest exposed ceiling, slab or roof underside, up to the next storey.
  • Overhead refuses if anything is in the way, such as furniture, a beam or a duct, or if the underside is hidden in the plan. Native ceiling-, floor- and roof-hosted families refuse before the click.

What stops a placement

Placing skips faces the view doesn’t show: hidden, filtered, outside the crop or past the far clip. A door, window, curtain panel, column, stair, cupboard or furniture in front stops it, as does starting inside a cut wall. Press Tab to step past to the face behind, except in a ceiling plan.