Labels marks a board’s circuits on the drawing: by default, text saying the board and circuit number, such as “U1-3”, by each device the view shows. Labels keep clear of each other, of the devices and of existing text and tags.
Label a board
Open a plan, section or elevation
In any other view, such as 3D, Labels says so once. The message goes when a view that takes text is active.
Click Labels
On a board’s page, Labels is in the footer. To label several boards, tick them in the board list and click Labels N.
Check what it reports
Labels reports any label you should move by hand. Text that names a circuit its device isn’t on is reported with Show in view.
Each board is one undo step, so Undo removes one board’s labels. Running Labels again adds nothing that is already there.
Text or tags
| `labelKind` | What Labels writes |
|---|---|
Text (default) | A text note with the board and circuit number. |
Auto | A native circuit tag where one is available (a tag type named for circuit, kurs or krets), otherwise text. |
Tag | Only tags; devices without a suitable tag type are skipped. |
Set these in the Circuits preferences file (Preferences…). labelFormat is BoardAndNumber (“U1-3”, the default) or Number. With a tag, the tag’s family decides what it shows.
What Labels does
- Gives each new label its own spot, including devices in a long row. A device too large for an outside spot gets its text at its centre, and that is reported.
- Skips a device that already has text saying its label within 25 mm on the sheet, whoever wrote it. “U1–3”, “U1: 3” and “U1-3” count as the same. In
AutoorTag, an existing circuit tag counts too. - Labels a device on two circuits “U1-3, U1-4”.
- Removes its own text labels that no longer label anything correctly, and labels those devices afresh, for example after a board is renamed or a device moves far away.
- Reports, but never changes, other text by a device that names a circuit the device isn’t on.
What it leaves alone
A label is Pembris’s only while it says exactly what Circuits wrote. A note you rewrote stays, and so do a label in a group and a pinned label, which are reported. A label with no free spot nearby overlaps and is reported for you to move by hand.
When Labels refuses
Labels refuses, changing nothing, rather than risk removing or doubling a label wrongly:
- in a read-only project, or when a label to remove belongs to another user;
- when the project has over 10,000 circuits, or a circuit has over 1,000 devices;
- when the view shows over 10,000 of the board’s devices, or holds over 4,096 text notes and tags;
- when the board’s Revit numbering scheme can’t be read safely, rather than guessing its prefix.